cat# These TNC cmds will be executed each time you start aprsd.
# Modify the MYCALL and BTEXT lines with your data.
# Add/delete any other commands your TNC needs for configuration.
# The last command "K" puts the TNC in communication mode and must be present.
# These sample commands are for a Kantronics KPC-3
# A ctrl-C is sent to the TNC from the server just before these commands are issued.
# Note: The TNCs user interface must have already been set for 9600 baud.
#
#
# Kenwood D700A commands
#
ECHO OFF
AUTOLF ON
CMSG ON
CTEXT Unmanned digi/igate, disconnecting now!
MCOM OFF
MSTAMP OFF
PASSALL OFF
MRPT ON
NEWMODE OFF
XMITOK ON
HEADERLN OFF
DIGIPEAT OFF
UIDIGI ON RELAY,CA
HID OFF
PACLEN 255
MONITOR ON
MYALIAS RELAY
#
# MYCALL must match MyCall in aprsd.conf
MYCALL W9IF
#
# You may turn off BTEXT here and use "tncbeacon" command in aprsd.conf instead
# 180 = 30 minutes on D700A
#BTEXT Poway, CA Home beacon, w9if@arrl.net
#BEACON EVERY 180
#
# Location beacon
#LTEXT !3300.28NI11701.96W&PHG7330/w9if@arrl.net Poway CA
#LOCATION EVERY 180
#
#Note: "APRS" below is overwritten by APDxxx (xxx is version number)
#So, it matters not what you put there.
#UNPROTO APRS VIA WA0RTO-5 WIDE1-1
#UNPROTO APRS VIA W5NVH WIDE2-2
#UNPROTO APRS VIA RELAY WIDE WIDE
#UNPROTO APRS VIA AD6NH-5 WIDE2-2
#UNPROTO APRS VIA WIDE,WIDE
#UNPROTO APRS VIA RELAY WIDE1-1
UNPROTO APRS VIA WIDE2-2
K
#
# end of file